First 3D Print


We spent some time with the new 3D Printers today and managed to create a few small trinkets from the stock files they sent with.  Our first impressions are very positive.  It took a while to get everything unboxed, setup and calibrated but never the less it was worth the wait.  Above is a nut and bolt we created.  It took about 30 minutes for the system to built it and another 15 minutes or so for the unit to heat up.  Setup time was less than an hour to get a single system calibrated and loaded with new filament (3D ink).


This entry was posted on Thursday, January 2nd, 2014 at 6:07 pm and is filed under 3D Printing and Imaging, DDMC Info. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

Leave a Reply

Your email address will not be published. Required fields are marked *